Description of DK Tank

Board size: 93 х 53 х 25 мм

Characteristics

  • Compatible with Heng Long and Taigen tank connectors.
  • The number of supported RC channels - from 4 to 8.
  • Fully compatible with Tamiya IR combat protocol. Support for other IR protocols: Heng Long, Taigen.
  • Motor control via internal regulators. Load up to 30 amperes at peak. Cut-off at high current consumption.
  • Support for single-drive gearboxes (clutch gearbox). Support for gearboxes such as DKLM or Tamiya Leopard 2.
  • Support for two external ESC.
  • Proportional control of the turret rotating and barrel elevating motors.
  • Support for up to 4 servomotors - cannon recoil, barrel elevation, turret rotation, steering wheel.
  • High quality two-channel audio. Built-in 3.5W audio amplifier, 4-8 ohm speaker support.
  • Support for 2S batteries (7.2 - 7.4V). Stopping the motors when the battery is over-discharged.
  • Connectors for LEDs: front lighting, rear lighting, brake light, flash, machine gun and reload indicator.
  • Supports high voltage flash.
  • Proportional operation of the smoke machine for the motor. The ability to turn on the smoke machine when fired or destroyed.
  • Additional 5 Volt TOGGLE jack for connecting external equipment, switchable via the remote control.
  • Configuring the board by editing the file on the microSD card. More than 100 options available.
  • Change sounds by saving files to a microSD card. The ability to install custom sounds.

Next

DK Tank
Announcement
DK Tank
Tank control board with support for 8-channel radio control, the ability to set your own sounds and many settings.
150 $
Contacts:
Purchase:

Online store DKLMRC

Sounds included

Basic sounds

Model Gun MG Cold start
T-34 76 mm DT source
KV-1 (IS-2) 76 mm DT source
Panzer III (Panzer IV) 50 mm MG 34
Tiger (Tiger II) 88 mm MG 34
Panther 75 mm MG 34
Sherman M4A1 (Pershing, Walker Bulldog) 75 mm M1919 Browning
T-72 125 mm 2A46 PKM
Leopard 2A5 (Т-90, M1 Abrams) 120 mm Rh120 MG 42

Extensions

Model Base set Gun MG Cold start
KV-2 KV-1 150 mm

Add-ons for DK Tank

DK Tank
IR LED TSAL6200
A common IR transmitter for combat systems. LED diameter 5 mm. JR connector, 30 cm long.
3 $
DK Tank
IR LED TSAL6200 3x
Wide range IR transmitter. Suitable for example for a bombardment. The diameter of the LEDs is 5 mm. JR connector, 30 cm long.
5 $
DK Tank
IR LED narrow beam
IR transmitter for combat systems SFH4550 angle ± 3 °. The beam is slightly narrower than the TSAL6200. LED diameter 5 mm. JR connector, 30 cm long.
5 $
DK Tank
IR receiver unidirectional
IR receiver for combat systems. Receives a signal from one direction. Connector XH2.54 3 Pins, length 30 cm.
5 $
DK Tank
IR receiver omnidirectional
LF0038Q IR signal receiver for combat systems. Receives a signal from all directions. Suitable for covert installation of the IR combat system on the model. It has a high sensitivity, so it makes sense to cover most of the receiver, leaving a 1-2 mm gap in a circle. Connector XH2.54 3 Pins, length 30 cm.
7 $
DK Tank
Adapter T-plug
Adapter for screw terminals to T-plug connector. Length 15 cm.
3 $
DK Tank
Adapters for TK6.x
A set of adapters for screw clamps to the DJ221-4 connector. Suitable for connecting the power and motors of the DK Tank board to Heng Long tanks with a TK6.x controller. In a set: 2 male adapters for power supply, 4 female adapters for connecting motors. Length 5 cm.
5 $
DK Tank
LED red 5 mm
LED diameter 5 mm. JR connector, 30 cm long.
2 $
DK Tank
LED white 5 mm
LED diameter 5 mm. JR connector, 30 cm long.
2 $
DK Tank
LED yellow 5 mm
LED diameter 5 mm. JR connector, 30 cm long.
2 $
DK Tank
LED white 3 mm
LED diameter 3 mm. JR connector, 30 cm long.
3 $